Optional Positioning Of Thermostat Sensing Bulb - Comfort Glow CGD3018N Owner's Operation And Installation Manual

OPTIONAL
POSITIONING
OF
THERMOSTAT
SENSING BULB
For Masonry and
Factory-built
Metal Fireplace
1O299O
If your log set cycles to pilot, but the room temperature drops to a lower
than ideal comfort level before the log set comes back on, you may want to
reposition the thermostat sensing bulb.
The thermostat sensing bulb is located near the gas valve assembly on the mounting
bracket. This location allows the thermostat to keep the room temperature at an ideal
comfort level for most fireplace applications. For positioning the thermostat sensing bulb
elsewhere, an adhesive-backed mounting clip has been provided.
Tools needed: 114" hex driver or socket
1. Remove logs. Locate the gas valve assembly and thermostat sensing blub (see Figure
26).
Gas Valve
Mounting Thermostat
Bracket Sensing Bulb
Figure 26. Location of Gas Valve Assembly and Thermostat Sensing Bulb
2. The adhesive-backed mounting clip (see Figure 27) is attached to the thermostat
sensing bulb. Remove the adhesive-backed mounting clip.
Figure 27. Adhesive-backed Mounting Clip
3. With 1/4" hex driver or socket, loosen the thermostat screw. Carefully slide the
thermostat sensing bulb out of the retaining clamp (see Figure 28).
Note: Do not remove the screw. Make sure you tighten the screw after removing the
thermostat sensing bulb.
IMPORTANT" Do not force or bend the thermostat sensing bulb or capillary.
Capillary
Retaining Clam_
Sensing Bulb
Figure 28 - Removing Thermostat Sensing Bulb
4. The thermostat sensing bulb may be located to the lower right front side of fireplace.
Determine location of sensing bulb, but do not mount sensing bulb until step 5. If you
have a masonry fireplace, see Figure 29 on page 30 for location.