PREPARATION& ASSEMBLY - Model P1450S,P1450S-CAN,P1600S,P1600S-BB, P1600S-CAN
Assembly Time: 5 minutes
Tools Required: 17mm or Adjustable Wrench
SurfacePreparation
•
Beforestartinganycleaningtask, it is importantto inspectthe area
for objectswhich couldcreatea hazard.
•
Remove anyobjectsfrom thework areawhich couldbe tripped
over,suchastoysor outdoorfurniture.
•
Ensure that all doorsandwindows are closedtightly.
Step 1
•
Remove or peel off blue protectivefilm on tile front of the pressure
washerand on the wands(if applicable).Also, remove anybubble
wrap. Discardblue protectivefilm and bubblewrap.
Step 2
•
Attach tile QuickConnectInlet couplingto water supplyinlet on
pressure washer,as shownin Figurebelow.
Step 5
•
Attachotherend of HighPressure Hoseto Gunasshown in Figure
below. Fastentightlywith 17mm wrenchto avoidleakage.
Step 6
•
AttachShoulder Strapto tile StrapBracketas shownin Figure
below.
Step 3
•
Attach WandBracketto tile unit asshown in Figurebelow.
Step 7
•
Attachtile hoseholderstrap to tile sideof tile unit asshown in
Figurebelow.
Step 4
•
Attach HighPressure Hose to MainUnit as shownin Figurebelow.
For Operating Instructions, proceed to page 9.
{m
8 of 18
STANLEYi Electric PressureWashers
Rev: Feb2011