Dhcp Or Pppoe Configuration - Fortinet FortiGate 500A Installation Manual

DHCP or PPPoE configuration

DHCP or PPPoE configuration
26
Table 5: NAT/Route mode settings
Administrator Password:
LAN
Port 1
Port 2
Port 3
Port 4
Port 5
Port 6
Network settings
You can configure any FortiGate interface to acquire its IP address from a DHCP or
PPPoE server. Your ISP may provide IP addresses using one of these protocols.
To use the FortiGate DHCP server, you need to configure an IP address range and
default route for the server. No configuration information is required for interfaces that
are configured to use DHCP.
PPPoE requires you to supply a user name and password. In addition, PPPoE
unnumbered configurations require you to supply an IP address. Use
record the information you require for your PPPoE configuration.
Table 6: PPPoE settings
User name:
Password:
01-28005-0101-20041015
IP:
Netmask:
IP:
Netmask:
IP:
Netmask:
IP:
Netmask:
IP:
Netmask:
IP:
Netmask:
IP:
Netmask:
Default Gateway:
Interface connected to
external network (usually
port2):
A default route consists of a default gateway and the name of the
interface connected to the external network (usually the Internet).
The default gateway directs all non-local traffic to this interface and
to the external network.
Primary DNS Server:
Secondary DNS Server:
NAT/Route mode installation
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
Table 6 to
Fortinet Inc.