Dhcp Or Pppoe Configuration - Fortinet FortiGate FortiGate-3000 Install Manual

NAT/Route mode installation

DHCP or PPPoE configuration

36
Table 11: NAT/Route mode settings
Administrator Password:
IP:
Internal
Netmask:
IP:
External
Netmask:
IP:
Port 1
Netmask:
IP:
Port 2
Netmask:
IP:
Port 3
Netmask:
IP:
Port 4
Netmask:
IP:
Port 4/HA
Netmask:
IP:
Port 5/HA
Netmask:
Default Gateway:
(Interface connected to
external network)
A default route consists of a default gateway and the name of the
Network settings interface connected to the external network (usually the Internet).
The default gateway directs all non-local traffic to this interface and
to the external network.
Primary DNS Server:
Secondary DNS Server:
You can configure any FortiGate interface to acquire its IP address from a DHCP
or PPPoE server. Your Internet Service Provider (ISP) may provide IP addresses
using one of these protocols.
To use the FortiGate DHCP server, you need to configure an IP address range
and default route for the server. No configuration information is required for
interfaces that are configured to use DHCP.
PPPoE requires you to supply a user name and password. In addition, PPPoE
unnumbered configurations require you to supply an IP address. Use
record the information you require for your PPPoE configuration.
Table 12: PPPoE
User name:
Password:
FortiGate-3000 and FortiGate-3600 FortiOS 3.0MR4 Install Guide
Configuring the FortiGate unit
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
Table 12
01-30004-0270-20070215
to