To Remove Belt - Dirt Devil 88150 Owner's Manual

TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE R ISK OF INJURY FROM MOVING PARTS -UNPLUG CLEANER BEFORE
CHANGING BELT OR BRUSHROLL.
TO REmovE BELT iBe, r style si
Lay cleanerflat and flip clean-
er to exposenozzlebase.Base
should layflat and face up. To
remove nozzle guard, use
Phillipsscrewdriverto remove
the tour (4) screws. Arrows
show locationof screws.
Lift nozzle guard off.
Slide belt off motor shaft.
TO REPLACE BELT OR BRUSHROLL
Lift and remove brushroll.
Dispose of old belt.
Place new belt in area of
brushroll without bristles.
Slide belt onto motorshaft.
With new belt in place, pull
andslide brushroll into nozzle
makingsurethat the brushroll
end caps are in the correct
orientation (Ta inset). Rotate
brushroll manually to make
sure belt is properly aligned.
Reattach nozzle guard.
lO
TAB TAB TAB
Secure by aligning the three
(3) tabs in the base slots.
Be sure to replace all four
(4) screws.