Install Cleanflow Air Filter; Complete The Installation; Prepare The Water System; Installing The Air Filter - Kenmore 106.5113 Series Use & Care Manual

4.
Complete the Installation
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
I. Plug into a grounded 3 prong outlet.
2. Flush the water system. See "Prepare the Water System" or
"Water and Ice Dispensers."
NOTE: Allow 24 hours to produce the first batch of ice. Allow
72 hours to completely fill ice container.
te
W® e_"
Please read before using the water system.
Immediately after installation,
follow
the steps below to make
sure that the water system is properly cleaned.
I. Open the freezer door and turn off the ice maker. The On/
Off switch can only be accessed when the ice
storage
bin
has been removed. The switch is
located
on the freezer
door,
on the left side of the wall that surrounds the ice storage bin.
Move the switch to the OFF (right) setting.
2.
Make
sure the water filter is properly installed.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
3.
Flush
the water system. Use a sturdy container to depress
and hold
the water dispenser lever for 5 seconds, then
release it for 5 seconds. Repeat until water begins to flow.
Once water begins to flow, continue depressing and
releasing the dispenser lever (5 seconds on, 5 seconds off)
until a total of 3 gal. (12 L) has been dispensed. This will
flush
air from the filter and water dispensing system, and
prepare the water filter for use. Additional flushing may be
required in some households. As air is cleared from the
system, water may spurt out of the dispenser.
Open the freezer door and turn on the ice maker. Move the
switch to the ON (left) position. Please refer to the "Ice
Maker and Storage Bin" section for further instructions on
the operation of your ice maker.
• Allow 24 hours to produce the first batch of ice.
• Discard the first three batches of ice produced.
• Depending on your model, you may want to select the
maximum ice feature to increase the production of ice.
On some models, your refrigerator's accessory packet includes
an air filter, which must be installed prior to use. On some
models, the air filter is already installed at the factory.
The air filter reduces the buildup of odors. This helps to maintain
a cleaner environment inside the refrigerator.
Installing the Air Filter (on some models)
The filter should be installed behind the vented door, which is
located (depending on your model) along either the rear or left
interior wall near the top of the refrigerator comoartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place.
4. Close the vented door.
13