A&D TM-2430 Instruction Manual page 16

Attach the cuff to the patient. Refer to "Attaching the Cuff
Step 8
and Recorder".
Attach the carrying case to patient and insert the recorder.
Step 9
Refer to "Attaching the Cuff and Recorder".
Start the automatic measurement. The recorder displays
Step10
an "A". Refer to "Automatic Measurement".
The recorder starts the automatic measurement sequence.
Step11
Check the recorder using the manual measurement with
relaxed, but correct posture. Refer to "Manual Blood Pressure
Measurement".
When using automatic measurement, consider the following.
Step12
Consider the sections "Patient instructions" and "Notes
on the Blood Pressure Recorder".
When
measurement, press the
rising and going to bed.
When the automatic measurement sequence is finished,
Step13
turned off "A" sign. Refer to "Automatic Measurement".
Detach the cuff and recorder from the patient.
Step14
Transfer the patient's data and save it to other media.
Step15
Refer to "Data transfer".
Clean the cuff and recorder and place in storage. Refer to
Step16
the sections "Before use" and "Maintenance".
the patient uses mode II of
key with each
AUTO ON/OFF
Page 14
Previous page
Step 8
Step 9
Step 10
Step 11
Step 12
automatic
Step 13
Step 14
Step 15
Step 16
End