Table of Contents
Advertisement
LNB control
DiSEqC 1.0: Your satellite equipment receives signals from 2 to 4 satellites.
Multi-switches interconnect the satellite antennas. All LNBs are supplied with
power. Positions A to D are available. DiSEqC 1.0 is the default setting.
LNB power off: Power is not supplied to the LNBs. Irrespective of the adjust-
ment of your satellite system, your digital receiver can only receive the signals
of one satellite. Only position A is available.
No DiSEqC: Your SAT installation points to a single satellite only. The LNB is
supplied with power. DiSEqC control signals are off. Only position A is availa-
ble.
Toneburst: Your SAT installation receives signals from two satellites. Both
LNBs are supplied with power. Positions A and B are available.
DiSEqC sequence
Press the
or
DiSEqC signal to the satellite equipment. The correct value corresponds to the
number of multi-switches installed in your SAT equipment.
Options are to Send once, Send twice and Send three times.
Note: The receiver will separately send the DiSEqC sequence to each of the
multi-switches installed in the SAT equipment, i.e. three times if 3 multi-switches
are in place.
Positions A to D
Shows the satellites the receiver is attached to. In most cases, Position A is set
to Astra 1 (19.2°E) because this satellite broadcasts almost all favourite Central
European channels.
To add satellites:
1. Adjust your LNB control and DiSEqC sequence to match your satellite equipment.
2. Select Position B (C, D) and press OK.
3. Press the
or
etc.).
Note: The low-band and high-band "LOF values" are set to defaults and need not
normally be changed. Change these values only if your satellite TV provider
requires it, for example. These settings will be retained even if the appliance's fac-
tory defaults are restored.
4. Press the
or
Band-LOF box and enter the exact frequencies.
Enter the figures either using the arrow buttons or the numerical keys on the
remote control.
Press BACK followed by OK to acknowledge the prompt.
arrow to specify how often the digital receiver is to send the
arrow to select a satellite as appropriate (Astra, Hotbird, Turksat
arrow to go first to the Low-Band-LOF and then to the High-
71
Operation
Advertisement
Table of Contents
