Dial-In Modem Mode; Serial-Port Parameters - Belkin OmniView User Manual

Serial Ports
In order to terminate a telnet/SSH/RawTCP session in terminal-server mode, you may
use these three control-key sequences (Ctrl-Z / Ctrl-X / Ctrl-C).
Dial-in Modem Mode
In this mode, the Console Server assumes an external modem is attached to the serial
port and waits for a dial-in connection from a remote site. When a user dials in using
a terminal application, the Console Server will accept the connection and display the
appropriate prompt or menu for the user that logged in.
Serial-to-Serial Mode
Please refer to the "Serial-to-Serial Function" section on page 34 for details for this
mode.
Serial-Port Parameters
To connect the serial device to the Console Server's serial port, the serial-port
parameters of the Console Server should match exactly to the requirements of the
attached serial device.
29