Advertisement
Available languages
Available languages
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vac-
uum cleaner, the agitator must be cleaned
every time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use
HEAVY
-
(used daily)
MODERATE
-
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
Clean Agitator
every week
every month
every 2 months
IMPORTANT
Disconnect vacuum cleaner from electrical
outlet. Check and remove hair, string and
lint build-up frequently in the PowerMate
agitator and end cap areas.
Remove
any dirt or debris
in the belt path
area or in the brush roller
area.
Cor move
any string
or de-
•
bris located
on
the agitator
or
end caps.
AGITATOR
ASSEMBLY
-End
Cap
Beret Path
1
°ro,!O°.
TO REPLACE BELT
NOTE: Use replacement
belt No. 20-40118,
see part number detail in REPLACEMENT
PARTS (page 7).
1. Install new
belt over
motor drive,
then over belt
path.
2P,aceag,
Drive
tatar assem-
\ -_
_=t Path
bly back into
Agitator
EndCap
PowerMate.
3. Verify that end
cap is pressed
firmly into position.
3. Line up front of cover and base.
Rest
cover on front edge of base as shown.
Base
_
_ 4. Rotate cover
__
back. Press cover
__-'_k,__=_._i
firmly
unti, side
and rear latches
Side
Rear
snap into place.
Latch
Latches
Make sure there is no gap between the
cover and base.
5. Turn PowerMate upside down and re-
place two (2) cover screws.
- 25 -
Advertisement
