Dust Bag Changing; Motor Safety Filter Changing - Sears Kenmore Vacuum Cleaner Owner's Manual

TO REPLACE BAG:
Fold the safety
seal tab on the
new dust bag
away from the
opening that
fits on the dust
tube.
Dust Bag
NOTE: Use bag #20-50688.
#20-50680_
Unfold the new dust bag.
O
Seal Tab
In Canada,
Insert the dust
bag onto the
dirt tube com-
pletely by hold-
ing the bag col-
lar and pushing
it onto the dirt
tube.
Position the
dust cover
so its posi-
tioning tabs
fit into the
body posi-
tioning slots.
Dust
Tabs
Close the dust
cover.
You will hear a
distinct snap
when dust
cover is secure-
ly Closed.
Check the motor filter occasionally and
replace when dirty.
WARNING
Electrical Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is properly installed to prevent
motor failure andtor electrical
shock.
Always unplug power cord from
electrical outlet before performing
any service on vacuum.
MOTOR SAFETY FILTER
ELECTROSTATIC
Remove the dust bag as outlined in the
DUST BAG CHANGING section.
This white and grey filter must be replaced
when dirty_ It should be replaced regularly
depending on use conditions_ The filter
CANNOT be washed as it will lose its
dust trapping ability.
Motor
Safety
If the filter, located in the bottom of the dust
bag cavity, is dirty, remove by pulling for-
ward out from under the ribs.
Replace the filter, white side Up, by sliding
it back into place under the ribs in the dust
bag cavity.
Replace the dust bag as outlin,ed in the
DUST BAG CHANGING section_
13