Installation; To Drill Fl'om Inside; To Drill Fl'om Bottom - GE Monogram ZEM200 Series Installation Instructions Manual

Installation
Microwave Oven
To drill
from inside
(continued)
-Position remaining piece of Template 2 inside
cabinet and align hole center line with arrows
on Template 1.
Cut excess paper from center of Template 2 so
it will lie flat.
-Distance fl'om right hole center to left hole
center should measure distance indicated on
template.
Tape remaining portion of Template 2 in
place.
• With template secured in place, check again
that hole center lines on Template 2 are
straight, and that distance fl'om right to left
hole center measures distance shown on
template.
To drill from
bottom
• Position Template 2 flat against underside of
cabinet:
If cabinet is less than 12" deep, cut that
amount off fl'ont edge of template.
-If cabinet has a fl'ont rail, cut fl'ont edge of
template to fit: place cut edge against back
of fl'ont rail.
Cut template to fit around corner brackets
or glue blocks underneath cabinet.
If cabinet
has a
partition
If cabinet has partition:
- Cut Template 2 into two pieces to fit on
either side of partition.
Align fl'ont edge of one template piece with
fl'ont edge of cabinet or back of fl'ont rail;
tape in place.
-Tape Template 1 to rear of cabinet,
aligning arrow with hole center line on
Template 2.
Position remaining piece of Template 2
under cabinet and align hole center line
with arrows on Template 1.
-Cut excess paper fl'om center of Template 2
so it will lie flat.
Distance from right hole center to left hole
center should measure distance indicated
on template.
-Tape remaining portion of Template 2 in
place.
13