GE Monogram ZEM200 Series Installation Instructions Manual page 8

Installation
MJ('I'O Wa Ve Oven
JX8 2 7
installation
Toolsandmaterials
required:
• AccessorykitJX827for
in-wallinstallation
• 2Phillipsheadscrewdrivers
(#1 & #2)
• Drilland3/32"drill bit
• Centerpunch or nail
• Pencil a ndruler
JX827 Parts List
1. BasePan
2. Rear Duct
3. Side Covers (2)
4. Top Trim
5. Bottom Trim
6. Side Trims
7. Rear Holddown Brackets
Screws A (9 required 1 extra)
B (4 required 1 extra)
C (10 required 2 extra)
D (4 required 1 extra)
E (4 required 1 extra)
Screw A Screw B
Parts Inventory
Screw C Screw D Screw E
Step 1
Install rear
holddown
brackets
Screw C
Notch
Screw B
• Set tile base pan into cabinet cutout and
center left and right. Front flange should be
pushed back against fl'ont wall, flush with
opening.
• Use the V-notch in the base pan fl'ont flange
to center.
• Drill two 3/32" diameter holes into the base
supporting structure, using the two holes in
the base pan fl'ont flange as a guide.
• Drive two screws into the base pan fl'ont
flange to ternt)orarily hold in place.
• Slide two rear holddown brackets into slots
in the rear of base pan. Tongues should be
sticking into the base pan and centered in
the slot.
• Mark and drill foul" 3/32" holes.
• Install both brackets with 2 screws B.
• Remove two screws in the base pan fl'ont
flange and slide the base pan straight out.