Electrolux EI30GF35JSA Use & Care Manual page 39

Self-clean
Setting self-clean (cont'd) Setting delayed self-clean
To cancel self-clean:
.
2.
Press thecancel @ key.
If the self-clean cycle has heated the oven to a
high temperature, "Hot" (Figure 1) will show in
the display. Allow enough time for the oven to
cool and for the "door OPn" message to
display (Figure 2). When this message turns
OFF the oven door may be opened.
Fig. 1 Fig. 2
Starting self-clean after cancelling:
If a self=clean cycle was cancelled using the
cancel key before the oven was finished cleaning,
you may wish to set for another self-clean cycle.
If self-clean was cancelled shortly after being
started, and the oven interior did not reach high
self-clean temperatures, the next clean cycle may
be set as soon as the oven door unlocks from the
cancelled clean cycle.
If the oven became hot enough from the cancelled
self-clean cycle, you may be required to wait up to 4
hours before the control will allow another self-
clean cycle to start.
Restarting a self-clean cycle after a power
outage:
If the self-clean cycle was interrupted by a power
failure, your oven may not be thoroughly cleaned.
Another self-clean cycle may be needed. Once
power is restored, the oven has cooled and the
oven door has unlocked, set to clean for another
cycle.
Setting repeated self-clean cycles
If attempting to set repeating self-clean cycles, the
control may display the messages "CLEAn"" then
"dELAy" followed by the length of time before the
next self-clean may be set.
For example, if the message displayed reads
"4:00", and the time is 12:00 o'clock, the control will
not allow self-clean to be set again until after 4:00
o'clock.
You may wish to set your appliance to perform a
self=clean cycle later (up to 12 hours later). The end
time key will determine when the cleaning will stop.
You will need to set the end time far enough to
allow for the type of clean cycle you choose,
whether for 2, 3, or 4 hours Remember to add
30 to 40 additional minutes of cooling time before
using the oven for cooking.
Setting for a heavy (4 hour) self-clean cycle to
end at 8:00 o'clock:
Step Press
1 Be sure the clock is set with the
correct time of day. Remove all
oven racks, Remove all items
from the cooktop. Be sure the
oven door is completely closed.
2. Press end time.
Ph
==)l
3. Enter 8 0 0 using the numeric
keypad.
4. Press START,
800
4>
5. Press self clean.
2|,_
6. Press self clean again.
7. Press START.
2|,_
4>
Press CANCEL at any time to stop self-clean
CAUTION
To avoid possible burns use caution when
opening the oven door after the self-clean cycle is
finished. The oven may still be VERY HOT.
Stand to the side of the oven when opening the
door to allow hot air or steam to escape.