Dell Vostro 410 Service Manual page 18

1 screws (2)
3 data cable
4. Disconnect the power and data cables from the back of the floppy drive.
5. Disconnect the data cable from the system board.
6. Remove the two screws securing the floppy drive.
7. Slide the floppy drive out through the front of the computer.
8. If you are not replacing the drive, reinstall the drive panel insert (see Media Card
9. Replace the bezel (see Replacing the Computer
10. Perform the steps in the procedure
11. Check the system setup for the appropriate diskette Drive Option changes (see
Replacing or Adding a Floppy Drive
1. Follow the procedures in Before Working on Your
2. Remove the computer cover (see
3. Remove the bezel (see Removing the
4. If you are installing a new floppy drive rather than replacing a drive, remove the break-away metal plate from the FlexBay (see
Break-Away Metal Plate).
5. Gently slide the floppy drive into place in the FlexBay from the front of the computer.
6. Align the screw holes in the floppy drive with the screw slots on the left side of the FlexBay slot.
7. Tighten the two screws to secure the floppy drive.
8. Attach the power and data cables to the floppy drive.
9. Connect the other end of the data cable to the connector labeled "FLOPPY" on the system board (see
2 floppy drive
4 power cable
Cover).
After Working on Your Computer.
Computer.
Removing the Computer Cover).
Bezel).
Reader).
Entering System Setup).
System Board
Removing the FlexBay
Components).