Removing A Floppy Drive - Dell Vostro 410 Service Manual

1 screws (2) 2 hard drive
3 slot 4 screws (2), partially inserted
5 power cable 6 data cable
7. Connect the power and data cables to the drive.
8. Connect the data cable to the system board.
9. Check all cables to be certain that they are properly connected and firmly seated.
10. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
11. Connect your computer and devices to electrical outlets, and then turn them on.
12. See the documentation that came with the drive for instructions on installing any software required for drive operation.
13. Check the system setup for drive configuration changes (see
Floppy Drive
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

Removing a Floppy Drive

1. Follow the procedures in Before Working on Your
2. Remove the computer cover (see
3. Remove the bezel (see Replacing the
Replacing the Computer Cover).
Entering System
Computer.
Removing the Computer Cover).
Bezel).
Setup).