3. Click Uninstall.
4. See the program documentation for installation instructions.
drive letter :\ is not accessible. The device is not ready —
Insert bootable media —
Insert a bootable floppy disk, CD, or DVD.
Non-system disk error —
Remove the floppy disk from the floppy drive and restart your computer.
Not enough memory or resources. Close some programs and try again —
you may have to restart your computer to restore computer resources. If so, run the program that you want to use first.
Operating system not found —
Contact Dell (see
Keyboard Problems
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Check the keyboard cable —
Ensure that the keyboard cable is firmly connected to the computer.
l
Shut down the computer, reconnect the keyboard cable, and then restart the computer.
l
Ensure that the cable is not damaged or frayed and check cable connectors for bent or broken pins. Straighten any bent pins.
l
Remove any keyboard extension cables and connect the keyboard directly to the computer.
l
Test the keyboard —
Connect a properly working keyboard to the computer, then try using the keyboard.
Run the Hardware Troubleshooter —
Lockups and Software Problems
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
The computer does not start up
Check the diagnostic lights —
See
Ensure that the power cable is firmly connected to the computer and to the electrical outlet
The computer stops responding
CAUTION:
You may lose data if you are unable to perform an operating system shutdown.
Turn the computer off —
If you are unable to get a response by pressing a key on your keyboard or moving your mouse, press and hold the power button for
at least 8 to 10 seconds (until the computer turns off), and then restart your computer.
A program stops responding
The drive cannot read the disk. Insert a disk into the drive and try again.
Contacting
Dell).
See
Hardware
Troubleshooter.
Diagnostic
Lights.
Close all windows and open the program that you want to use. In some cases,