Dell Dimension 4600C Service Manual page 30

5. Check all connectors to be certain that they are properly cabled and firmly seated.
6. Close the computer cover.
7. Attach the computer stand
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
8. Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
PC Card Module (Optional)
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Owner's Manual or Product Information
Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1. Shut down the computer through the Start menu.
2. Turn off your computer and any attached devices.
3. Ground yourself by touching an unpainted metal surface on the chassis, such as the metal around the card-slot openings at the back of the computer,
before touching anything inside your computer.
While you work, periodically touch an unpainted metal surface on the computer chassis to dissipate any static electricity that might harm internal
components.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
4. Disconnect your computer and devices from their power sources. Also, disconnect any telephone or telecommunication lines from the computer.
5. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
6. Remove the computer stand, if it is attached.
7. Open the computer cover.
8. If you are installing a new PC Card module instead of replacing a module, remove the front-panel insert by pressing the tabs on either side of the insert
and lifting the insert up.
(optional).