Fujitsu BS2000/OSD Operation Manual page 43

Standard processing in SVP mode
Overview of the SVP function keys
The following overview shows the keys and their functions as valid for most SVP frames. In
some SVP frames keys can have another function. This is then shown in the corresponding
SVP frame description.
Some of the keys shown here only have a function in CE mode (see information below) and
are used exclusively by the service department.
i
The designations of the SVP function keys are different on the screen from those on the
EMDS keyboard mask. Column 1 of the following table contains the designation of the SVP
function keys on the screen (example: PF4), column 2 contains the corresponding keys on
the EMDS keyboard mask.
PF . .
PF1
PF 2
PF 3
PF 4
PF 5
PF 6
PF 7
PF 8
PF 9
PF 10
PF 11
PF 12
PF 13
PF 14
PF 15
PF 16
PF 17
U25339-J-Z126-1-7600
CE=Customer Engineer; the CE mode on the S130 can only be switched on and off
by the service department using a key switch on the inside of the maintenance
panel.
P . . Name
Help
P1
Index
P2
Return
P3
P4
P5
Cancel/Erase Input Command or input is erased.
P6
Page up
P7
Page down
P8
P9
P10
P11
P12
Recall
P13
P14
P15
Change CPU
P16
P17
Function
Help functions
Only in CE mode : switches to the index frame
Switches to the previous frame.
Frame-specific function is executed.
Frame-specific function is executed.
The previous screen contents are displayed.
The next screen contents are displayed.
Frame-specific function is executed.
Frame-specific function is executed.
Frame-specific function is executed.
Frame-specific function is executed.
Previous SVP commands are displayed in the
command line; they can then be executed again with
changed operands.
Frame-specific function is executed.
Frame-specific function is executed.
Selects the CPU for which the following commands
are valid. This CPU is then logically connected to the
SVP.
not assigned.
Using frames
43