Straight Stitch; Use The Seam Guides; Turn A Square Corner - Kenmore 385. 17922 Owner's Manual

• Straight Stitch
f
Set the Machine
Stitch width
Top thread tension
control 2 to 6
A: Zigzag foot
H: Straight foot
Stitch length
control red
zone
Stretch Stitch
NOTE:
Best sewing results are
obtained with the straight
stitch foot, but the zigzag
foot will also provide
acceptable results.
I
Before sewing with the straight stitch
foot, atways set the stitch width
control to 0 to avoid breaking the
needle.
1. Raise the presser foot.
2. Raise the needle to its highest
position,
3. Place the edge of the fabric next
to a stitching guide fine on the
needle plate (5/8" _s most
common),
4. Draw the threads toward the back
and lower the presser foot,
5. Press the foot control,
8,
Hold the fabric loosely and gently
guide it along the guide line, so
that it feeds naturally,
Do not force the fabric or try to
pull it t_ght,
7,
8,
9.
At the beg}nning and end of the
seam, you may want to reverse to
lock the stitch.
Raise the presser foot and remove
the fabric,
Cut the threads.
Use the Seam Guides
Comerlng gu=de
The seam guides on the needle plate
are engraved to help you measure seam
width. The lines are 1/8" apart, with
the 5/8" and 7/8" lines marked.
* Turn a Square Corner
guide
J
To turn a square corner 5/8" from the
fabric edge:
1. Stop stitching and lower the
needle by turning hand wheel
toward you when the fabric edge
facing you lines up w_th the
cornering guide, as shown.
2. Raise the presser foot and turn
the fabric to line the edge with
the 5/8" seam guide.
3. Lower the presser foot and begin
stitching in the new direction.
3I