Acura 2010 TL Owner's Manual page 288

You can also adjust the sound by
pushing the (Sound) button
repeatedly. Each mode is shown in
the center display as you push the
button.
Turn the VOL/ knob or
interface knob to adjust the setting
to your liking. You can check the
level on the navigation screen or on
the center display. When the level
reaches the center, you will see ''C''
in the center display.
Playing the AM/FM Radio (Models with navigation system)
The system will return to the audio
playing mode in the center display
about 10 seconds after you stop
adjusting a mode.
If you do not make an adjustment
within 10 seconds, you will need to
select the mode again.
BASS/TREBLE To adjust bass
and treble, select BASS or TREBLE,
and press ENTER on the interface
selector. The current setting is
shown on the display. Turn the
interface dial or VOL/
the desired level, and enter your
selection by pressing ENTER on the
interface selector.
2010 TL
FADER/BALANCE
modes adjust the strength of the
sound coming from each speaker.
Fader adjusts the front-to-back
strength, while balance adjusts the
side-to-side strength. To adjust fader
and balance, select FADER or
BALANCE, then press ENTER on
the interface selector. The current
setting is shown on the screen. Turn
the interface dial or VOL/
to the desired level, and enter your
selection by pressing ENTER on the
interface selector. To equalize the
knob to fader or balance, turn the interface
dial or VOL/
marks on the sound grid come to the
center of the adjustment bar.
If the fader adjustment is set to F9
(maximum front level), the
subwoofer is turned off.
These
knob
knob until the
CONTINUED
285