Sony PDWHR1 Installation Manual page 13

21. Connect the coaxial cable (connected to the VPR-15
board) and the harness (connected to the NET-5 board)
to the connectors on the DPR-321 board, and arrange
them as shown in the figure.
CN902 CN901 CN900
Green Blue
DPR-321 board
Red
X202
Coaxial cable
Pass the coaxial cable between
the chassis and the board.
22. Push the redundant portions of the harness and the
coaxial cable into inside the chassis, and attach the
cable cover.
Push the redundant portions of the harness
and the coaxial cable into inside the chassis.
PDBK-MK1
Do not extend the coaxial
cable above X202.
CN2100
Harness
Collect the redundant
portions of the harness
and the coaxial cable here.
Cable cover
23. Remove the two screws from the bottom panel assem-
bly of the PDW-HR1 to detach the slot cover.
Bottom panel assembly
Slot cover
24. Install the bottom panel assembly to the PDW-HR1.
(Refer to step 8.)
25. Install the slot cover sub assembly with the supplied
two screws.
n
Push the slot cover sub assembly against portion A of
the bottom panel assembly and tighten screws.
Portion A
Slot cover sub assembly
26. Install the rear panel assembly to the PDW-HR1.
(Refer to step 1.)
B3 x 6
Bottom panel assembly
B3 x 6
1-5 (E)