On-Board Triggers - Honeywell VISTA 15P - Ademco 6 Zone Control Panel Installation And Operation Manual

Installation and Setup Guide

On-Board Triggers

2-12
Connect field wiring to the desired trigger pin on the 8-pin trigger connector centrally
located above the terminal strip.
• If using 1361X10 transformer and powerline carrier devices, use the SA4120XM-1
cable (part of 4120TR Trigger Cable). See Wiring the AC Transformer section for
transformer connections.
• If only using the on-board triggers, you can use a 4-wire cable (N4632-4, supplied
with the control) as shown below.
8-PIN TRIGGER CONNECTOR
1 3 4 5 6 7 8
SA412OXM-1
CABLE
Figure 15a. On-Board Trigger Connector
with SA4120XM-1 Cable for Use With
1361X10 Transformer
• Trigger outputs are normally high, and go low upon programmed condition.
• The outputs can be programmed for inverted operation (normally low, go high) using
*79 Menu mode.
• Program these triggers using *80/*81 Menu modes as you would for any other relay
output.
• When using these outputs, note:
pin 1 = output number 17 (trigger 1):
15 ohms to ground when closed (output low), open when off (output high, normal
default); can be used to reset smoke detector power (must set "output normal low
= yes" in *79 Menu mode, and set for zone type 54, fire zone reset, in *80 Menu
mode); or can support 12V relay module (
than 100mA
pin 5 = output number 18 (trigger 2):
100 ohms to ground when closed (output low); open when off (output high,
normal default); or can support 12V relay module that draws less than 20mA
U L
If on-board triggers are used, the wiring between the control unit and the UL Listed device must
be run in conduit, be no more than 3 feet apart and have no intervening barriers or walls.
8-PIN TRIGGER CONNECTOR
1
00-trigcon-003-V1
Figure 15b. On-Board Trigger Connector
with 4-Wire Cable for Trigger Use Only
e.g., Altronix AX-RBS)
3 4 5 6 7 8
4-WIRE
CABLE
00-trigcon-005-V2
that draws less