Ps3 Component Setup - Plantronics RIG User Manual

PS3 component setup

1
2
3
4
5
6
7
Make sure the boom mic is attached properly to the RIG headset. Insert the 3.5mm plug into the
headset jack on the front of the mixer located under the RIG logo tab, on the left side.
Connect the USB cable from the RIG mixer into an available USB port on the PS3.
Attach the included 3.5 adapter/RCA piggyback to the end of the long 3.5 mm plug cable.
Attach the RCA piggyback in between the PS3 AV cable (included with all PS3 models) and the
primary audio source (TV, receiver, etc).
PRO TIP
Connect the USB cable from the RIG mixer into a USB port on the PS3. For proper function,
make sure that the USB connector is plugged into the PS3 itself and not an external USB power
source.
Set the audio settings on the PS3. Go to: Settings > Accessory Settings > Audio Device Settings >
Input Device (select "Plantronics RIG") > OK
Find a good balance of game and voice audio by adjusting the [GAME/CHAT SOUND] balancer
on the right side of the mixer (over the orange LEDs). Remember that the 3 o'clock position will
enable equal volume of both game and voice audio signal. Sliding the control
game sound louder and voice (game chat) quieter. Sliding the control
(game chat) while making game audio quieter.
R
L
V
upward makes
downward increases voice
14