Sony Playstation 3 (Ps3) Setup; Ps3 Optical Cable Setup - Plantronics RIG User Manual

Sony Playstation 3 (PS3) setup

PS3 optical cable setup

How you connect your PS3's audio/video to your TV will generally be the
most important factor in how audio is connected to the RIG Mixer.
Use this setup if your TV or primary audio device has an optical port and if you have an optical
cable (not included in package, sold separately by other manufacturers). An optical cable is an
optional connection method that offers the highest performance audio possible with the RIG
Mixer.
1 Make sure the boom mic is attached properly to the RIG headset. Insert the 3.5mm plug into the
headset jack on the front of the mixer located under the RIG logo tab, on the left side.
2 Attach a Toslink digital optical cable to the appropriate port on your Playstation 3, HDTV, A/V
Receiver, or other audio device.
3
Plug the opposite end of the optical cable into the optical port on the rear of the RIG Mixer.
4 Set the audio settings to enable chat with the RIG mic on the PS3. Go to: Settings > Accessory
Settings > Audio Device Settings > Input Device (select "Plantronics RIG") > OK
5
Set the audio settings on the PS3 to output both TV (HDMI) and the RIG Mixer. Go to: Settings >
Sound Settings > Audio Output Settings > Audio Multioutput > On
6 Find a good balance of game and voice audio by adjusting the [GAME/CHAT SOUND] balancer
on the right side of the mixer (over the orange LEDs). Remember that the 3 o'clock position will
enable equal volume of both game and voice audio signal. Sliding the control
game sound louder and voice (game chat) quieter. Sliding the control
(game chat) while making game audio quieter.
R
L
V
upward makes
downward increases voice
13