Table of Contents
Advertisement
Symptom
Your notebook won't work on battery alone.
T r o u b l e s h o o t i n g
Possible Cause
2. You are operating on battery only and have
ignored a low battery alarm until the batteries
are all at the dead battery state and your
into Dead Battery Suspend mode.
3.You have a battery failure.
4. Your power adapter has failed or lost it's
power source.
1. The installed batteries are dead.
2. No batteries are installed.
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
Possible Solution
2. Install a Power adapter and then push the
Suspend/Resume button. (See Low Battery
State on pages 28–29.) machine has gone
3. Verify the condition of the batteries using
the Status Indicator panel (Figure 2-3 on
page 19), and replace or remove any that
are shorted.
4. Make sure the adapter is plugged in and the
outlet has power.
1. When the batteries are dead there will be a
beep when the power switch is turned on
and the notebook will immediately go into
Dead Battery Suspend mode. (See pages
28–29.) Replace the battery with a charged
one or install a Power adapter.
2. Install a charged battery. (See Multi-function
Bay Devices on pages 117–120 and Battery
Bay on pages 128–129.)
159
Advertisement
Table of Contents
