Table of Contents
Advertisement
on the module should be on the right with
the part side up and the connector pointing
towards the back of the notebook and
aligned with the notch in the connector
inside the compartment. (Figure 4-15.)
9. Insert the memory upgrade module at a 45°
angle. (Figure 4-16.) Press the connector
edge of the module firmly down and into
the connector.
10. Press the memory upgrade module down
into the compartment until it lodges under
the retaining clip. You will hear a click when
it is properly in place.
11. Repeat for the second memory upgrade
module if desired.
12. Replace the cover by sliding the tabs on the
rear edge of the cover in the slots in the rear
edge of the compartment and pushing the
cover gently down starting with the rear
edge and working toward the front until the
entire cover is flush with the bottom of your
notebook. Make sure that the side tab o f the
U s e r
I n s t a l l a b l e
Figure 4-15 Installing/Removing a
Memory Upgrade Module
cover goes under the edge of the compart-
ment and that the Multi-function Bay 2
Release button moves freely.
13. Replace the screws.
14. Replace the device in Multi-function Bay 2.
(See page 118.)
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
Memory upgrade modules are not something
you routinely remove from your notebook.Once
they are installed,leave them in place unless you
want to increase system memory capacity.
C A U T I O N
Before you install or remove a memory
upgrade module, save changes, close all
files and turn power off to your note-
book. (See Power Off on Pages 24–25.)
135
Advertisement
Table of Contents
