Table of Contents
Advertisement
Electrical Specifications
Table 3-7. Voltage and Current Specifications (Continued) (Sheet 3 of 3)
Symbol
I
DPRSLP1
I
DPRSLP1
dI
CC/
DT
I
CCA
I
CCP
NOTES:
1. The typical values shown are the VID encoded voltages. Static and ripple tolerances (for minimum and
maximum voltages) are defined in the load line tables i.e.,
loadline specifications for the Pentium M processor is required to ensure reliable processor operation.
2. The voltage specifications are assumed to be measured at a via on the motherboard's opposite side of the
processor's socket (or BGA) ball with a 100-MHz bandwidth oscilloscope, 1.5-pF maximum probe
capacitance, and 1-Mohm minimum impedance. The maximum length of ground wire on the probe should be
less than 5 mm. Ensure external noise from the system is not coupled in the scope probe.
3. Specified at V
4. Specified at the VID voltage.
5. The I
CCDES
designed to this specification.
6. Based on simulations and averaged over the duration of any change in current. Specified by design/
characterization at nominal V
7. Measured at the bulk capacitors on the motherboard.
8. Pentium M processors LV and ULV will support VCCA supply voltages of both 1.8 V ±5% and1.5 V ±5%.
9. Deeper sleep voltage of 0.726 V (typical) is supported on LV and ULV Pentium M processors with CPU
signature =06D8h. A typical voltage setting between 0.726 V and 0.748 V may be used but the minimum and
maximum voltages specified in
10.For 733J, CPU signature = 06D8h.
30
Parameter
I
Deeper Sleep @
CC
0.748 V for Pentium M
Processors:
765/755/745/778/758/738/
735/725/715
753/733J/733/723
I
Deeper Sleep @
CC
0.726 V for Pentium M
Processors:
765/755/745/778/758/738/
735/725/715
753/733J/733/723
V
power supply current
CC
slew rate
I
for V
supply
CC
CCA
I
for V
supply
CC
CCP
(nominal) under maximum signal loading conditions.
CC,STATIC
(max) specification comprehends future processor HFM frequencies. Platforms should be
. Not 100% tested.
CC
Table 3-7
Min
Typ
Max
2.5
1.6
2.3
1.3
0.5
120
2.5
Table 3-8
through
should not be exceeded.
Unit
Note
A
4, 9, 10
A
4, 9, 10
A/ns
6, 7
mA
A
Table
3-21. Adherence to
Datasheet
Advertisement
Table of Contents
