Topology - Dell PowerConnect B-RX Configuration Manual

E

Topology

Commands
snmp-server enable traps
<trap-type>
snmp-server enable traps holddown-time <secs>
snmp-server host <ip-addr> [0 | 1] <string> [port <value>]
snmp-server location <string>
snmp-server trap-source loopback <num> | ethernet
<slot/port> | ve <num>
sntp poll-interval <1-65535>
sntp server <ip-addr> | <hostname> [<version>]
static-mac-address <mac-addr> ethernet <portnum> [to
<portnum> ethernet <portnum>]
[priority <number>] [host-type | router-type | fixed-host]
system-max ip-static-route <num>
system-max subnet-per-interface <num>
system-max subnet-per-system <num>
terminal length <number-of-lines>
unknown-unicast limit <number>
Topology
Commands
master-vlan <vlan-id>
member-group <num>
member-vlan <vlan-id>
show topology-group [<group-id>]
topology-group <group-id>
1348
See ...
"Disabling SNMP traps" on page 120
"Setting the SNMP Trap holddown time"
"Specifying an SNMP trap receiver"
"Entering system administration information"
page 117
"Specifying a Single trap source"
"Specifying a Simple Network Time Protocol (SNTP)
server" on page 124
"Specifying a Simple Network Time Protocol (SNTP)
server" on page 124
"Assigning static MAC address entries to priority
queues" on page 473
"Displaying and modifying system parameter default
settings" on page 131
"Displaying and modifying system parameter default
settings" on page 131
"Displaying and modifying system parameter default
settings" on page 131
"Configuring terminal display"
"NP based multicast, broadcast, and
unknown-unicast rate limiting"
See ...
"Configuring a topology group"
"Configuring a topology group"
"Configuring a topology group"
"Displaying topology group information"
"Configuring a topology group"
BigIron RX Series Configuration Guide
on page 119
on page 118
on
on page 119
on page 130
on page 507
on page 441
on page 441
on page 441
on page 441
on page 441
53-1001986-01