Dell PowerConnect B-RX Configuration Manual page 1316

49
IPv6 PIM sparse
Displaying RP information for a PIM sparse group
To display RP information for a PIM Sparse group, enter the following command at any CLI level.
BigIron RX#show ipv6 pim rp-hash ff1e::1:2
RP: 2001:3e8:255:255::17, v2
BigIron RX#
Syntax: show ipv6 pim rp-hash <group-addr>
The <group-addr> parameter is the address of an IPv6 PIM Sparse IP multicast group.
This display shows the following information.
This field...
RP
Info source
Displaying the RP set list
To display the RP set list, enter the following command at any CLI level.
BigIron RX#show ipv6 pim rp-set
Number of group prefixes Learnt from BSR: 1
Group prefix = ff00::/8
BigIron RX#
Syntax: show ipv6 pim rp-set
This display shows the following information.
This field...
Number of group prefixes
Group prefix
RPs expected/received
RP <num>
1244
Info source: 2001:3e8:255:255::17, via bootstrap
# RPs received: 1
RP 1: 2001:3e8:255:255::17
Displays...
The number of IPv6 PIM Sparse group prefixes for which the RP is responsible.
Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
Indicates how many RPs were expected and received in the latest Bootstrap
message.
Indicates the RP number. If there are multiple RPs in the IPv6 PIM Sparse
domain, a line of information for each of them is listed, and they are numbered in
ascending numerical order.
Displays...
Indicates the IPv6 address of the Rendezvous Point (RP) for the specified
IPv6 PIM Sparse group.
Following the IPv6 address is the port or virtual interface through which this
device learned the identity of the RP.
Indicates the IPv6 address on which the RP information was received.
Following the IPv6 address is the method through which this device learned
the identity of the RP.
# RPs expected: 1
priority=0 age=0
BigIron RX Series Configuration Guide
53-1001986-01