Delay Start; Intensive Drying - Bosch SHE7PT52UC Operating Instructions Manual

Instructions for use
Hide thumbs Also See for SHE7PT52UC:
Table of Contents

Advertisement

Available languages

Available languages

Interrupt a cycle
1
Press the [On/Off] button to turn the unit off.
2
To resume the cycle, press the [On/Off] button again.

Delay Start

You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button. Select a cycle.
2
Press the [Delay] button until the displayed time corresponds with
your requirements and press [Start] to activate delay start.
h:01 = 1 hour delay h:24 = 24 hour delay
To cancel delay start:
1
Press the [Delay] button until "h:00" is indicated on the digital display.
2
Press [Start] to save setting.
Cycle Completion Signal
1
Open the door and press the [On/Off] button.
2
Hold down the "A" button (see page 17) and press [Start] until the
display indicates "d:00". Release both buttons.
3
Press the "A" button until the display shows "b:02".
4
Press the "C" button to increase or decrease the tone "b:00" = OFF and
"b:03" = LOUDEST and press [Start] to save setting and close the door.

Intensive Drying

The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1
Press the [On/Off] button.
2
Hold down the "A" button and press [Start] until the display indi-
cates "d:00". Release both buttons
3
Press the "A" button until the display shows "d:00".
4
Press the "C" button to turn intensive drying on or off. "d:01" = ON
and "d:00" = OFF and press [Start] to save setting.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. Auto Power Off can be adjusted from P:00 to P:02.
To change the factory setting (P:01):
1
Press the [On/Off] button.
2
Hold down the "A" button and press [Start] until the display indi-
cates "d:00". Release both buttons.
3
Press the "A" button until the display indicates "P:01".
4
Press the "C" button until the display corresponds with your require-
ments.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5
Press [Start] to save the setting
.
18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents