Lenovo ThinkServer TS430 User Manual page 156

• For the 2.5-inch hot-swap hard disk drive cage, install the six screws to secure the backplane on
the cage.
Figure 83. Installing the 2.5-inch hot-swap hard disk drive backplane
12. Slide the hard disk drive cage into the chassis from the front until it snaps into position.
Note: The following illustration shows the 3.5-inch hard disk drive cage. For the 2.5-inch hard disk
drive cage, the installation procedure is the same.
Figure 84. Installing the hard disk drive cage
13. Reinstall all the hot-swap hard disk drives and dummy trays (if any) in the hard disk drive cage. See
"Installing or replacing a hot-swap hard disk drive" on page 127.
14. Refer to your note to reconnect the cables to the backplane.
15. Reinstall the front system fan. See "Replacing the front system fan" on page 157.
16. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 89.
144
ThinkServer TS430 User Guide