Part Names And Functions - Fujitsu Plasmavision PDS4233W User Manual

PART NAMES AND FUNCTIONS (Continued)
Remote Control
1
3
8
PUTTING BATTERIES IN THE REMOTE CONTROL
1 To remove the cover, slide it
outwards while pressing it down.
CAUTION:
Be sure to use replacement batteries of the same type as the original ones.
When disposing of used batteries, please comply with governmental regulations or environmental
public institution's rules that apply in your country/area.
Note
The remote control will not function properly if the batteries are dead. Be sure to replace them as needed.
10
1 Power ON button [POWER ON]
Turns the power ON.
2
2 Power OFF button [POWER OFF]
5
4
Turns the power OFF.
3 RGB input mode selector button [RGB]
6
Switches between RGB input modes.
7
4 Video input mode selector button [VIDEO]
Switches between video input modes.
9
5 Wide screen selector button [WIDE]
Switches the screen over to a desired wide screen.
6 Menu button [MENU]
= Use this button to display a desired menu for adjusting the picture.
7 Volume adjustment buttons [VOL +/-]
Adjust the volume.
8 Adjustment buttons [
Use these buttons to scroll through options in a menu and change values.
9 Enter button [ENTER]
Press this button to finalize the selection of a desired menu or option within a menu.
0 Display selector buttons [SHIFT 1–4]
When you use two or more displays, you can use these buttons to control up to four displays
by assigning a unique number to each display.
2 Place two AA batteries in the
remote control. Make sure that the
batteries are properly oriented.
Press the + button to increase the volume.
Press the - button to reduce the volume.
/ / / ]
3 Close the cover until it snaps into
(See P . 14.)
(See P . 14.)
(See P . 15.)
(See P . 15.)
(See P . 16–17.)
(See P . 18–39.)
(See P . 14.)
(See P . 18–39.)
(See P . 18–39.)
(See P . 36 .)
place.