Fujitsu Plasmavision PDS4233W User Manual page 27

• Adjusting Contrast (Contrast)
Any value between -30 and +30 can be selected.
: Higher contrast
: Lower contrast
Press to store.
• Adjusting Screen Brightness (Brightness)
Any value between -60 and +60 can be selected.
: Brighter screen
: Darker screen
Press to store.
• Adjusting Color Darkness (Color)
Any value between -60 and +60 can be selected.
: Darker colors
: Lighter colors
Press to store.
• Adjusting Tint (Tint)
Any value between -30 and +30 for [
: More greenish colors
: More purplish colors
Press to store.
• Adjusting picture Sharpness (Sharpness)
Any value between -16 and +16 for [
: Sharper pictures
: Less sharp pictures
Press to store.
• Setting Picture Mode (Picture Mode)
Can set up the picture mode.
Each time you press or , one of the available choices appears in the following sequence:
Dinamic:Suitable for watching a normal motion picture.(Standard)
Fine: Suitable for watching a dark picture such as movie.
Real 1: Makes a strong contrast picture.
Real 2: Makes a bright color picture.
Static: Suitable for watching a still picture.
Press to store.
*Select Dinamic, Fine, Real 1, Real 2 or Static to suit your taste.
• Adjusting Color Temperature (Color Temp.)
Use or to specify a desired color temperature. Each time you press
Warm: More reddish colors
Standard:Standard color temperature
Cool: More bluish colors
User: User Color Temp. setup
Press to store.
• Setting User Color Temp. (User Color Temp.)
Can set up when User is selected in Color Temp.
Press or to select Red, Green or Blue and press
of 0 to 255.
Press to store.
* Color Temp. setup is switched to User. The initial value of User Color Temp. is adjusted
individually at the factory.
• Setting Noise Reduction (Noise Reduction)
Can select the noise reduction setting corresponding to the noise level of the input signal.
Each time you press or ,one of the available choices appears in the following sequence:
Off: Noise reduction does not function.
Min.: Weak setting
Std.: Standard setting
Max.: Strong setting
Press to store.
*Some type of signal can not be selected.
], and -60 and +60 for [ ] can be selected.
(Decoder)], and -4 and +4 for [
or
or to make adjustment in the range
(RGB-PC)], can be selected.
, one of the available choices appears in the following sequence:
User Color Temp.adjustment screen
25