Fujitsu SRS-9924 User Manual page 57

At the conclusion of selecting buttons for Call
Announce Intercom, this screen appears:
1. Press ENTER. If one or two way intercom is
enabled, the screen displays the enabled mode
plus the authorized DN, as shown below:
If no telephone numbers have been programmed
in, the Call Announce Intercom feature is disabled,
and the screen displays NON SUPPORTED:
To program the first number and enable Call
Announce Intercom, go to step 2.
ENTER
2.
1: ONE WAY - speaker is activated on the
recipient' s set, but the microphone is off.
2: TWO WAY - both speaker and microphone
are active.
3: TURN OFF - intercom feature is disabled.
3. Press 1 or 2, then ENTER. A screen appears
showing your choice and prompting for an
authorized DN:
3
3-21