Core Specifications - Asus PC-DL Deluxe User Manual

1.4.2 Core specifications

SSI-type power connector (24-pin). This 24-pin connector connects to
1
an SSI power supply. The power supply must have at least 1A on the +5V
standby lead (+5VSB).
2
CPU sockets. Two 604-pin surface mount, Zero Insertion Force (ZIF)
sockets for Intel
533MHz system bus that allows up to 4.3GB/s data transfer rates.
3
North bridge controller. The Intel
(MCH) provides the CPU interface, DDR interface, AGP interface, and
Hub Interface, and manages the flow of information between these
interfaces. The MCH provides the processor interface with 533MHz
frequency, system memory interface with up to 5.33GB/s bandwidth in
dual-channel mode, and 1.5V AGP Interface Specification 3.0 that
supports 8X/4X Fast Write protocol. The MCH interconnects to the south
bridge ICH5R via the Intel
4
SSI-type 12V connector. This power connector connects the 8-pin 12V
plug from the SSI power supply.
5 DDR DIMM sockets. These four 184-pin DIMM sockets support up to
4GB system memory using unbuffered ECC or non-ECC PC2700/
PC2100 DDR DIMMs.
6
AGP Pro/8X slot. This Accelerated Graphics Port (AGP) Pro slot
supports 0.8V/1.5V AGP 8X mode graphics cards for 3D graphical
applications and delivers up to 2.1GB/s bandwidth.
7
RAID Ultra ATA133 connector (supported by Promise
controller) . This connector supports two Ultra ATA133 HDDs. On RAID
models, the HDDs on this connector may be configured as RAID0,
RAID1, or RAID0+1 together with the Serial ATA HDDs on the SATA
RAID connectors.
8
SATA connectors (supported by Promise
These connectors support Serial ATA HDDs and allows for up to
150MB/s data transfer rate using the thin 4-conductor SATA cables.
The HDDs may be configured as RAID0, RAID1, RAID0+1. Together
with the UltraDMA133 devices, if present, the HDDs may be set up as
a multi-RAID configuration.
9
Flash ROM. This 4Mb firmware hub (FWH) contains the programmable
BIOS program.
10
SATA connectors (supported by ICH5R) . These connectors support
Serial ATA HDDs and allows for up to 150MB/s data transfer rate. The
HDDs may be configured as RAID 0/RAID 1 level storage.
1-8
® Xeon™ processors with 512KB L2 cache, and
®
® proprietary Hub Interface.
82875P Memory Controller Hub
® PDC20378 controller) .
Chapter 1: Product introduction
® PDC20378