Rs485 Communication Parameters (Dip Switch 1) - Panasonic WV-CW594 Installation Manual

■ RS485 Communication Parameters (DIP Switch 1)

Configuring DIP Switch 1 as shown below resets communication parameters to their factory default settings. You can
then change the settings as desired.
DIP Switch 1
ON
This setting resets communication parameters to the factory default settings.
1 2 3 4 5 6 7 8
ON
BAUD RATE : 19 200 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bit
1 2 3 4 5 6 7 8
ON
BAUD RATE : 9 600 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bit
1 2 3 4 5 6 7 8
ON ON
BAUD RATE : 4 800 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bit
1 2 3 4 5 6 7 8
ON ON
BAUD RATE : 2 400 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bit
1 2 3 4 5 6 7 8
Perform the following steps to use this setting.
(1) Turn off the camera and use DIP Switch 1 to configure RS485 communication parameters as shown above.
(2) Turn on the camera.
This applies the setting you configured in step (1).
(3) Turn off the camera, use DIP Switch 1 to set the unit number ( ☞ pages 13 and 14), and then turn the camera
back on again.
Setting Description
15