Fujitsu Siemens Computers D1241 User Manual page 31

3. HARDWARE SETUP
12) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as the
PCI-L101 Ethernet card (see 7. APPENDIX). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: This feature requires that Wake On LAN or PCI Modem card
is enabled (see 4.5.1 Power Up Control) and that your system has an ATX power
supply with at least 720mA +5V standby power.
R
CUR-DLS
CUR-DLS Wake-On-LAN Connector
13) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that Wake On LAN or PCI Modem card
is enabled (see 4.5.1 Power Up Control) and that your system has an ATX power
supply with at least 720mA +5V standby power.
R
CUR-DLS
CUR-DLS Wake-On-Ring Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
WOL_CON
+5 Volt Standby PME
Ground
WOR
1 2
Ground Ring#
User's Manual 27