Fujitsu Siemens Computers D1241 User Manual page 27

3. HARDWARE SETUP
3) Universal Serial BUS Ports 0 & 1 (Black two 4-pin USB)
Two USB ports are available for connecting USB devices.
USB 1
Universal Serial Bus (USB) 2
4) Fast-Ethernet Port Connector (RJ45) (optional)
The RJ45 connector is optional at the time of purchase and is located on top of
the USB connectors. The connector allows the motherboard to connect to a Lo-
cal Area Network (LAN) through a network hub.
RJ45
5) Parallel Port Connector (Burgundy 25-pin PRINTER)
You can enable the parallel port and choose the IRQ through Onboard Parallel
Port (see 4.4.2 I/O Device Configuration).
NOTE: Serial printers must be connected to the serial port.
6) Serial Port Connectors (Teal/Turquoise 9-pin COM1/COM2)
Two serial ports can be used for pointing devices or other serial devices. See
Onboard Serial Port 1 in 4.2.2 I/O Device Configuration for settings.
Parallel (Printer) Port (25-pin female)
COM 1 COM 2
Serial Ports (9-pin male)
User's Manual 23