Xerox 4400DT - Phaser B/W Laser Printer Service Manual page 52

Error Message Summaries (cont'd.)
Note: The messages listed in the "Diagnostic Message" column
appear only in Service Diagnostics while printing Engine
Test Prints. The code numbers in these messages also
appear as part of the Help information displayed when you
press i.
Front Panel Diagnostic
Message Message
No Paper In Tray [#] Empty
Tray [#]
Press i.
Load Tray [#] PSE-1: Paper Size
with [paper size] Error
[paper type].
Close Front Close Front
Cover Cover/Close Rear
Cover
Close Rear
Cover.
Press i.
Install or Reseat E9-1: Duplex Unit
The Duplex Fail.
Unit.
Press i.
Stacker Failure. E9-2: Stacker Unit
Fail
Press i.
Install or Reseat E9-E: Envelope
the Envelope Feeder Fail/Reinstall
Feeder
Press i.
Tray 2 or 3 E11: Tray 2/3 Fail
Failure
Press i.
or
Tray 2 Failure
Press i.
Phaser 4400 Laser Printer Service Manual
Error Description Troubleshooting
Tray [#] is out of
paper.
Paper Size Error.
1. Front cover
interlock is open.
2. Rear cover
interlock is open.
Duplex module
removed while power
is on.
Stacker removed
while power is on.
Envelope feeder
module removed
while power-on.
Either Tray 2 or Tray
3 was disconnected
after power-on.
Procedure
Load paper into Tray [#].
Go to No Paper in Tray [#].
on page 2-41.
Load correct size paper in
tray.
Go to Load Tray [#] with
[paper size] [paper type].
page 2-42
Close Front Cover.
Close Rear Cover.
Go to Close Front
Cover/Close Rear Cover.
on page 2-31.
Reinstall Duplex Module.
Go to Install or Reseat the
Duplex Unit. on page 2-36.
Reinstall Stacker.
Go to Stacker Failure.
page 2-37.
Reinstall Envelope Feeder.
Go to Install or Reseat the
Envelope Feeder. on
page 2-37.
Reinstall Feeder 2/3.
Go to Tray 2 or 3 Failure.
on page 2-52.
on
on
2-15