Location Status - Pioneer AVIC-505 Owner's Manual

Location status

This allows you to correct for errors in your vehicle's position as shown on the map and to
select or reset the memory in which the built-in gyrosensor's learning results are stored. At the
same time, the number of GPS satellites from which signals are currently being received is
displayed along with the speed pulse rate (indicating your vehicle's speed) and your calculated
longitude and latitude. You can use this display to check correct operation of the GPS and
proper connection of the speed pulse cable.
Displaying the location status
A list of four options is displayed along with the following location status information.
1 Present longitude and latitude
2 GPS positioning mode (--, 2D, or 3D)
For "2D" and "3D" definitions, please refer to "What is GPS?" on page 130.
3 Speed pulse rate
Number of pulses per second (allows verification that pulses are being properly picked up)
CAUTION
• Releasing the handbrake while the "LOCATION STATUS" screen is being
displayed will enable the options shown on the screen ("MODIFY CURRENT
LOCATION", "GPS STATUS", "SELECT CALIBRATION MEMORY",
"RESET CALIBRATION MEMORY"). For safety reasons, the driver should not
attempt any of these operations while driving. (If a passenger is present, the
passenger should carry out these operations.)