Asus MAXIMUS VI FORMULA User Manual page 106

GPU.DIMM Post
Automatically detects and displays the information about the devices or memory installed on
the PCIe and DIMM slots. The field shows N/A if there are no devices installed on the slots.
DIGI+ Power Control
CPU Load-Line Calibration [Auto]
Load-line is defined by Intel
CPU working voltage will decrease proportionally to CPU loading. Higher load-line
calibration could get higher voltage and good overclocking performance but increases
the CPU and VRM thermal conditions.
Select from Level 1 to Level 8 to adjust CPU power voltage from 0% to 100%.
•
•
CPU Voltage Frequency [Auto]
Switching frequency affects the VRM transient response and the thermal component
conditions. Higher frequency gets quicker transient response.
Configuration options: [Auto] [Manual]
DO NOT remove the thermal module when setting this item to [Manual]. The thermal
conditions should be monitored.
The following items appear only when you set the CPU Voltage Frequency to [Auto].
The following item appears only when you set the CPU Voltage Frequency to [Manual].
VCCIN MOS Volt Control [Auto]
This is the driving voltage for the MOSFET on the VCCIN Rail.
Configuration options: [Auto] [Manual] [Active VGD]
3-16
VRM specification and affects CPU power voltage. The
®
The actual performance boost may vary depending on your CPU specification.
DO NOT remove the thermal module. The thermal conditions must be monitored.
VRM Spread Spectrum [Disabled]
Enable the VRM Spread Spectrum to enhance system stability.
Configuration options: [Disabled] [Enabled]
Active Frequency Mode [Disabled]
Enable the Active Frequency Mode for an enhanced power saving
condition.
Configuration options: [Disabled] [Enabled]
CPU Fixed Frequency [XXX]
This item allows you to set a fixed CPU frequency. Use the <+> or <-> keys
to adjust the valinterval.
Chapter 3: BIOS setup