Bushnell First Strike 730005 User Manual page 7

be mounted on the weapon by following these steps:
1. Loosen the mounting screw so that the clamp will
fit over the tapered side of the firearm's Picatinny
or Weaver rail.
2. Insure that the tapered clamp on the riser is
oriented with the chamfered (beveled) end of the
clamp at the top (Fig. 1).
3. Ensure that the riser's cross screw with nut is
tightened to clamp it firmly to the weapon's rail
(Fig. 2). Turn the large nut on the riser block ¼ to
½ turn with a coin, screwdriver or ½" wrench.
WARNING! Do not over tighten.
4. Complete zeroing according to the "Zeroing Your
First Strike" section that follows.
Fig. 1
AR730005/AR730005C
Fig. 2
7