Dell Force10 C150 Manual page 48

Command
interface management port
config 100m
interface management port
config 10m
interface management port
config auto-negotiate
interface management port
config no auto-negotiate
interface management port
config full-duplex
interface management port
config half-duplex
interface management port
config show
show interface management
ethernet
interface management ethernet
ip-address ip-address-
ip address
mask
BOOT_USER # show interface management ethernet
No IP address set for interface management ethernet 0/0!
BOOT_USER # interface management ethernet ip address 1.2.3.4/24
Management ethernet 0/0 IP address: 1.2.3.4/24
boot zero {default | primary
| secondary}
reload
Refer to the FTOS Command Line Interface Reference for BOOT_USER mode commands and
commands for run-time modes.
48 | System Boot
Purpose (continued)
• Use these commands to set the speed and duplex settings for the Management
interface.The default setting is full-duplex and auto-negotiation.
• Use the interface management port config show command to
view the Management interface's physical settings.
• Use the show interface management ethernet command to
display the IP address and network mask of the management Ethernet port.
• If the show command output does not display configured IP address
information, use the interface management ethernet ip
ip-address ip-address-mask
address
the Management Ethernet port for network (ftp/tftp) operating system boot.
Use CIDR block notation for the subnet mask.
Delete the boot configuration.
Reload software.
The autoboot program initializes and displays self-test results on the console
screen.
NOTE:
Do not press break control sequence at any time during the boot/
reboot process. Doing so causes the boot process to terminate.
command to set the IP address of