Dell Force10 C150 Manual page 44

Step Task (continued)
Extend the left and right card levers by first pressing gently down on the thumb tabs (see
2
levers and then pulling the ejector levers simultaneously until they are in the open position. See
Figure 11-3. Depressing the Thumb Tabs
Figure 11-4. Extending the Levers
Pull the card by the card levers until it is out of the slot. Avoid touching the printed circuit board and connector
3
pins.
If you are not replacing the RPM, insert an RPM blank panel.
4
If you are replacing the RPM, follow the instructions in
5
44 | Removing and Replacing Components
Installing RPMs and Line Cards on page
Figure 11-3) in the ejector
Figure 11-4.
19.