Terminal Panel Features - NEC NP-PH1400U User Manual

Terminal Panel Features

13 11
1. COMPUTER 1 IN/ Component Input Connector (Mini D-Sub 15 Pin) (→ page 15, 170, 175)
2. COMPUTER 2 IN / Component Input Connector (Mini D-Sub 15 Pin) (→ page 170, 175)
3. COMPUTER 3 IN/Component (R/Cr, G/Y, B/Cb, H, V) Connectors (BNC × 5) (→ page 170, 175)
4. HDMI IN Connector (Type A) (→ page 171, 172, 176)
5. DisplayPort IN Connector (DisplayPort 20P) (→ page 171)
6. MONITOR OUT (COMP 1) Connector (Mini D-Sub 15 Pin) (→ page 173)
7. VIDEO IN Connector (BNC) (→ page 174)
8. S-VIDEO IN Connector (Mini DIN 4 Pin) (→ page 174)
9. LAN Port (RJ-45) (→ page 177)
10. USB Port (Type A) (→ page 82)
11. PC CONTROL Port (D-Sub 9 Pin) (→ page 237)
Use this port to connect a PC or control system. This enables you to control the projector using serial communica-
tion protocol. If you are writing your own program, typical PC control codes are on page 237.
12. REMOTE Jack (Stereo Mini)
Use this jack for wired remote control of the projector using a commercially available remote cable with ⌀3.5 stereo
mini-plug (without resistance).
Connect the projector and the supplied remote control using a commercially available wired remote control cable.
(→ page 11)
NOTE:
• Connecting the remote cable to the REMOTE mini jack on the terminal panel will make the wireless operation unavailable.
13. USB (LAN) Port
14. Optional Slot (SLOT) (→ page 223)
9 4
12
(for optional Wireless LAN Unit) (→ page 178)
5 10
2
7
1. Introduction
3 1 7
14 6
8