NEC NP-PH1400U User Manual page 146

CONTROL ID �����������������������Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-
NOTE:
• When [ON] is selected for [CONTROL ID], the projector cannot be operated by using the remote control that does not support
the CONTROL ID function. (In this case the buttons on the projector cabinet can be used.)
• Your setting will not be affected even when [RESET] is done from the menu.
• Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Control
ID.
Assigning or Changing the Control ID
1. Turn on the projector.
2. Press the ID SET button on the remote control.
The CONTROL ID screen will be displayed.
If the projector can be operated with the current remote control ID, the
[ACTIVE] will be displayed. If the projector cannot be operated with the
current remote control ID, the [INACTIVE] will be displayed.To operate
the inactive projector, assign the control ID used for the projector by
using the following procedure (Step 3).
3. Press one of numeric keypad buttons while pressing and holding
the ID SET button on the remote control.
Example:
To assign "3", press the "3" button on the remote control.
No ID means that all the projectors can be operated together with a
single remote control. To set "No ID", enter "000" or press the CLEAR
button.
TIP: The range of IDs is from 1 to 254.
4. Release the ID SET button.
The updated CONTROL ID screen will be displayed.
NOTE:
• The IDs can be cleared in a few days after the batteries are run down or re-
moved.
• Accidentally pressing any one of the buttons of the remote control will clear
currently specified ID with batteries removed.
ting�
132
5. Using On-Screen Menu