Terminal Panel Features - NEC VT45 User Manual

Terminal Panel Features

7
S-VIDEO
IN
VIDEO
IN
6
1. RGB Input Connector(Mini D-Sub 15 pin)
Connect your PC or other RGB equipment. Use the supplied
signal cable to connect to a PC.
2. RGB Monitor Output Connector (Mini D-Sub 15 pin)
You can use this connector to loop your computer image to an
external monitor from the RGB input source.
3. Audio Input (Mini Jack)
This is where you connect audio output from your computer.
4. Audio Input (RCA)
This is where you connect audio output from a VCR, DVD
player, or laser disc player.
5.Audio Output (Mini Jack)
Connect audio equipment to this jack. Note that this cannot be
used as a headphone jack.
(When audio equipment is connected, the projector speaker is
disabled.)
When a cable mini-plug is inserted into this jack, both the
right and left audio signals are not mixed, but separate.
For example, when a cable mini-plug is inserted into the left
AUDIO IN jack only, only left sound is output.
NOTE1: ON AUDIO IN/OUT
The audio input (mini jack) 3 is available for RGB source only.
The audio input (RCA) 4 is available for Video or S-Video source
only.
The audio output (mini jack) 5 operates when audio source 3 or
4 is selected.
NOTE2: During Stand by Condition
RGB signal will be sent to the connected external monitor. Audio
signal will not be sent to the audio output.
4 5 2
AUDIO
RGB OUT CONTROL
L/MONO OUT
IN
R IN IN
RGB IN
3 1
8
PC
L/M ONO
IN
IN
IN
R
IN
IN IN
AC AC
6. Video Input (RCA)
Connect a VCR, DVD player, laser disc player, or document
camera here to project video.
7. S-Video Input Port (Mini DIN 4 Pin)
Connect the S-Video input from an external source like a VCR.
8. PC Control Port (Mini DIN 8 Pin)
Use this port to connect your PC to control your projector.
This enables you to use your PC and serial communication
protocol to control the projector. If you are writing your own
program, typical PC control codes are on page E-43.
E–11
PC
RO L
CO NT
OU T
RG B
OU T
IN
RG B
IN