8.1.4.
Documents The Unit Can Send
8.1.4.1.
Using the Scanner Glass
Note:
• Confirm that there are no documents in the automatic document feeder.
• Place the original onto the scanner glass gently. Do not press down too firmly to avoid malfunction.
• If the original is a thick book, do not close the document cover.
• Check that any ink, paste or correction fluid has dried completely.
• Effective scanning area is as follows:
Effective scanning area
8.1.4.2.
Using the automatic document feeder
Note:
• Confirm that there are no documents on the scanner glass.
• Check that any ink, paste or correction fluid has dried completely.
• Remove clips, staples or other fasteners.
• Do not insert the following types of documents: (Make a copy of the document using the scanner glass and set the copy instead.)
-Chemically treated paper such as carbon or carbonless duplicating paper
-Electrostatically charged paper
-Badly curled, creased or torn paper
-Paper with a coated surface
-Paper with printing on the opposite side that can be seen through the other side, such as newsprint
• The total height of the documents when laid flat, must be less than 5 mm. If the documents exceed the capacity of the automatic
document feeder, they may fall or cause a jam in the feeder.
• To set a document with a width of less than 210 mm, we recommend using the scanner glass to copy the original document onto
A4 or letter-size paper, then setting the copied document.
• Do not set documents that do not satisfy the requirements of size and weight. Make a copy of the document using the scanner
glass and set the copy.
• Available document size, document weight and effective scanning area are as follows:
147
KX-MC6020HX