Running Windows User Diagnostics - Dell QLogic Family of Adapters User Manual

User Diagnostics for Windows NIC Driver Management Applications: QLogic QME8242 Mezzanine Card User's Guide
Back to Contents Page
User Diagnostics for Windows NIC Driver Management
Applications: QLogic QME8242 Mezzanine Card User's Guide
This section covers the following information for user diagnostics for Windows NIC driver management applications:

Running Windows User Diagnostics

Windows Diagnostic Test Descriptions
Windows Diagnostic Test Messages
NOTE: The current release does not support external and internal loopback tests. Support is expected in a future
release.
Running Windows User Diagnostics
You can run user diagnostics using either the GUI or the CLI.
NOTE: Information on installing and starting the GUI version of
QConvergeConsole User's Guide. All procedural information for that utility is covered in the online help system.
To run user diagnostics in the GUI:
1. Access the Windows Control Panel, and then open the Device Manager.
2. In the Device Manager, right-click the QLogic 10 Gb Ethernet adapter, and then on the shortcut menu, click
Properties.
3. On the adapter properties page, click the Diagnostics tab.
Figure 1. Diagnostics Tests on Windows
file:///T|/htdocs/NETWORK/QLogic/71922/en/diag_win.htm[9/26/2012 4:26:06 PM]
QLogic's QConvergeConsole utility
Figure 1 shows the Diagnostics page.
is provided in the